济南德成铝业有限公司
联络人:李司理
手机:15614693658
德律风:0531-87887788
地点:济南市平阴县翠屏街东首
以后地位:万博manbetx-讯息资讯讯息资讯
铝板消费厂家教你折弯R角知识
2017-6-30 18:44:11

1.折弯R角的巨细。

1. bend R angle size.

铝板消费厂家折弯R角越大,那乐成率就越高,以是只管即便调大折弯R角越大。

Aluminum plate manufacturer bending R angle is bigger, that success rate ishigher, so as much as possible big bend, R angle is bigger.

2.铝板纹路偏向。

2. aluminum plate, grain direction.

折弯偏向要与铝板纹路偏向垂直,不克不及平行。

The direction of bending should be perpendicular to the direction of thealuminum plate and not parallel.

3.铝板的硬度。

3. hardness of aluminum sheet.

铝板硬度太高,很容易断裂。这就要求选择好铝材,次要看铝材牌号和形态。普通1系列、3系列、5系列的比拟常用;6系列、7系列的硬度太高,要先做退火处置到O态后才好折弯。另有便是铝板的质量,相反型号的铝板出口料就比国产料不容易开裂,但资料的价钱也是贵了不少。

铝卷消费厂家

The hardness of aluminum plate is too high to break easily. This requires agood choice of aluminum, mainly to see the aluminum brand and status. General 1series, 3 series, 5 series of more commonly used; 6 series, 7 series of hardnessis too high, should first do annealing treatment to O state only after bending.There is the quality of aluminum plate, the same type of aluminum plate,imported materials than domestic materials are not easy to crack, but the priceof materials is also a lot of expensive.

4.铝板的厚度。

Thickness of 4. aluminum plate.

太厚的铝板欠好折弯,各人一想就明确,只管即便运用薄一点的铝板。

The thick sheet of aluminum doesn't bend well, and everyone wants to seehow thin the aluminum sheet is.

5.需求拉丝的铝板零件,在工序容许的状况下最好是折弯后再拉形,不然会添加折弯断裂的概率。

5. aluminum parts need drawing, in the process allows, it is better to bendand then pull, otherwise it will increase the probability of bendingfracture.

本文由铝板消费厂家为您提供,我们的网站是:/我们将以一心一意的热情为您提供更优质的效劳,欢送您的拜访!

This article by the aluminum plate manufacturer provides for you, ourwebsite is: /, we will wholeheartedly wholeheartedlyprovide the higher quality service for you, welcome you to visit!